Discussions about commercial and domestic lighting fittings and fixtures (not streetlighting).
10 posts • Page 1 of 1
- ATL Admin
- Posts: 858
- Joined: Mon Jan 03, 2011 5:39 pm
- Favourite Manufacturer: Pre 1993 Thorn
- Area of interest: Fluorescent and Discharge Lighting
- Oldest item: One of a few pip top lamps!
- Location: Oxfordshire
Only on things like desk lamps, I've got an old twin 15w bench light with a push button starter. I've seen them on a couple of blacklight fittings too. I used to have one years ago and fitted a proper starter to it!
I LOVE LAMP!
- Posts: 275
- Joined: Wed Mar 02, 2011 5:43 pm
- Favourite Manufacturer: Thorn Atlas Mazda Omega
- Area of interest: Mercury Vapour and Fluorescent
- Oldest item: Siemens Sieray MB/V
- Location: Midlands
I used to have a 22w circular magnifying lamp with a push button starter. You needed to hold down the button down for a couple of seconds to preheat the tube.
I had the use of a manual start desk lamp once upon a time and I'd love to acquire one for my study but they are rare as teeth on a hen. Just for fun I put a press switch into an old starter body, it works a treat with
T8 lamps even 2 footers but T12s tend to self ignite.
- Posts: 273
- Joined: Tue Jul 12, 2011 7:56 pm
- Favourite Manufacturer: Thorn
- Area of interest: Fluorescent lighting
- Location: Guiseley
Tom_N wrote:Only on things like desk lamps, I've got an old twin 15w bench light with a push button starter. I've seen them on a couple of blacklight fittings too. I used to have one years ago and fitted a proper starter to it!
I thought this was the case, it'd be quite hilarious if they did it on ceiling fittings! I can just imagine people standing on chairs to start each lamp!
- Posts: 23
- Joined: Fri Nov 11, 2011 8:29 pm
- Favourite Manufacturer: Atlas
- Area of interest: Old Fluorescents and old Street Lights
- Location: Leicestershire
Back home we had a Tricity Marquis cooker it had a 15w
T8 fluro in the splashback/control panel that had the off/on push button switch incorporating a manual starter but mostly it used to self start.
- Posts: 660
- Joined: Wed Jan 05, 2011 7:01 pm
- Favourite Manufacturer: Fitzgerald
- Area of interest: Fluorescent and Mercury Discharge Lighting
- Oldest item: BTH 200W Carbon Filament Lamp
- Location: Cambridgeshire
Such a thing should be possible a 3 position reactive switch! Flick it down for preheat, wait a couple of seconds and release and the lamp should ignite. When you want to switch it off flick the switch up to break the circuit, extinguishing the arc and then when you release it the lamp shouldn't ignite again until preheated.
- Posts: 26
- Joined: Wed Oct 19, 2011 2:36 pm
- Area of interest: Low pressure gas discharge
- Location: Oxfordshire
I have one of the old manual start desk lamps, it has a great big square clunky push switch. Usually has to be held down for about 5 seconds minimum for the tube to strike properly. If not preheated the tube will still strike but it will only light dimly.
Who is online
Users browsing this forum: No registered users and 1 guest